I have a YaVDR ansible headless server with VDR 2.4.0. The tuner is DD Cine v.6.1. + 2 additional tuners connected to the main PCI-e card.
The server is providing signal to 4 clients in the house via VNSI and via Stremdevice-server.
Everything is working good except some weird effects.
When I use tuner0 i am always getting pixelization on some transponder (HD channels) on Bulsatcom.
Every single point of the chain from the sat dish to the DVB card has been extensively tested.
The LNB, the coaxial cables, F-connectors have been all exchanged to new. The satellite dishes has been re-aligned.
I have tested 4 different LNBs from different vendors and they all act the same. General Satellite, Invacom, Inverto Black, Televes they all have the same issue.
If tuner0 is locked to different satellite and I watch 39east via other tuner everything is fine.
As long as no client is connected to the server and I switch to Bulsatcom and tuner0 gets involved the pixelation begins.
Of course I thought that this is a hardware problem related to the DD Cine S2 tuner and I exchanged it to another spare one. The problem has not been saved.
Connecting all 4 cables one by one to a conventional DVB set-top-box gives a perfect picture with no pixelization on all cables so I am excluding a problem with the dish, LNB, cable or connector.
The log is clear with no obvious errors while I experience the weird pixelization.
If the problem cannot be spotted is there any way to disable tuner0 and prevent it to start once the server is rebooted.
I am ready to provide additional information for my setup if needed.
Thank you in advance.