Hi,
Das nächste Problem mit dem ich mich herumschlage ist, daß meine Nexus-S manchmal nicht korrekt initialisiert wird. Hier ist der Auszug aus dem dmesg:
ZitatAlles anzeigen
DVB: registering new adapter (Technotrend/Hauppauge WinTV Nexus-S rev2.X).
adapter has MAC addr = 00:d0:5c:23:78:1f
dvb-ttpci: load_dram(): timeout at block 0
dvb-ttpci: av7110_bootarm(): load_dram() failed
ACPI: PCI interrupt for device 0000:00:10.0 disabled
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
ACPI: PCI Interrupt Link [PIN2] enabled at IRQ 9
PCI: setting IRQ 9 as level-triggered
ACPI: PCI Interrupt 0000:00:12.0[A] -> Link [PIN2] -> GSI 9 (level, low) -> IRQ 9
DVB: registering new adapter (FlexCop Digital TV device).
b2c2-flexcop: MAC address = 00:d0:d7:0c:f6:2d
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: found the mt352 at i2c address: 0x0f
DVB: registering frontend 0 (Zarlink MT352 DVB-T)...
b2c2-flexcop: initialization of 'Air2PC/AirStar 2 DVB-T' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
Ich hab in dem System:
1 x Hauppauge Nexus-S
1 x Technisat Airstar2 DVB-T
Kernel ist jetzt 2.6.18 auf einer ct5 Installation.
Kann das thermische Gründe haben warum sie manchmal da ist und manchmal nicht?
bye
Marcus.