Hello to all, this is my first post here.
Since December 2010 I use yaVDR v0.3 with good results.
This week for the first time I would try yaVDR v0.4.
yaVDR v0.4. been installed several times, with different symptoms:
1st time: installation without TeVii S660 connected; TeVii is never been recognized.
2nd time: installation TeVii connected TeVii recognized after reboot.
but server (XBMC) XVDR loses every 5sec. the connection.
3th time: installation again, but forgot to connect the S660 TeVii
4th time: see note 2, and to repair this XVDR problem I did also:
# sudo apt-get update
# sudo apt-get dist-upgrade
and a black sreen of death apears (BSOD)
5th time: Menu key changed from KEY_PROG1 in KEY_MEDIA
There is a problem with MCE remote recognition.
Menu key is not recognized.
Back / Exit button is not recognized.
Some commands (only the Menu button from the remote)
# irw
94 0 KEY_PROG1 devinput
# pidof lircd
1020 538
# irw /var/run/lirc/lircd. $
connect: No such file or directory
# ir-keytable
Found / sys/class/rc/rc0 / (/ dev/input/event4) with:
Driver mceusb, table rc-rc6-mce
Supported protocols: NEC RC-5 RC-6 JVC SONY LIRC
Enabled protocols: NEC RC-5 RC-6 JVC SONY LIRC
Repeat delay = 500 ms, 33 ms repeat Period =
# ir-keytable -r
scancode 0x800f040d = KEY_PROG1 (0x94)
/etc/eventlircd.d/mce.evmap
KEY_PROG1 = # KEY_MENU Taste GO
/etc/vdr/remote.conf
LIRC.Menu KEY_MENU
Alles anzeigen
This is apparently not sufficient
/etc/eventlircd.d/mce.evmap
KEY_PROG1 = # KEY_MENU Taste GO
So I must change that line in LIRC.Menu KEY_PROG1 in /etc/vdr/remote.conf
only then the remote Menu-button responds on the TV-screen
Last time that I re-installed.
The MENU key is changed: KEY_MEDIA instead of KEY_PROG1
and XBMC loses connection with XVDR every 5 seconds,
Connected, Connection lost
The questions are:
Why is the remote does not fully recognize right after likewise in yaVDR v0.3 after a key-scan
Why lose XBMC the XVDR connection.
Thanks.
Henk.