Hallo,
könnte mir bitte jemand sagen, wie der channels.conf-Eintrag bei einer PVR150 für den Audio Line-IN aussehen muss?
Danke im voraus
lg, Gerhard
Hallo,
könnte mir bitte jemand sagen, wie der channels.conf-Eintrag bei einer PVR150 für den Audio Line-IN aussehen muss?
Danke im voraus
lg, Gerhard
D23B6 brauchst Du meines Erachtens nicht vorgeben (syntax vom analogtv-Plugin?)
Take the channels.conf in example dir as a reference for your own
channels.conf. You can also take a channels.conf from the analogtv plugin
and modify parameter, teletext and CA values. It is important to have the
following values for the channels:
Video PID: 301
Audio PID: 300
Teletext PID: 305
CA identifier: A1
for example:
RTL:217250:C0:C:0:301:300:305:A1:12003:1:1089:0
| | | | | | | | |
| | | | | | | | --> Transport Stream ID
| | | | | | | --> Network ID
| | | | | | --> Service ID
| | | | | --> CA identifier
| | | | --> Teletext PID
| | | --> Audio PID
| | --> Video PID (set to 0 for radio stations)
| --> Parameters (see below)
--> Frequency
Parameters:
With a frequency higher than 10000 kHz the tuner input of the PVR card is used.
The number of the tuner input should be detected automatically during startup
of the plugin. If this doesn't work you can specify it by setting the "C"
parameter of the channel entry to the right value. You also have to specify
this value if you want to use another input of the PVR card:
C0 - Input 0
C12 - Input 1
C23 - Input 2
C34 - Input 3
C45 - Input 4
C56 - Input 5
C67 - Input 6
C78 - Input 7
C89 - Input 8
C999 - Input 9
The video norm can be chosen in a similar way using the "I" parameter:
I0 - NTSC
I1 - SECAM
I999 - PAL
With no "I" parameter, PAL is used.
Alles anzeigen
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!