installation, OSD, key learning problem, vdr-sxfe

Hi,

I have recently reinstalled my VDR computer.
Since composite-out on my FF card is broken, I am trying to use vdr-sxfe instead.

I have done the setup and got VDR running, and I also have a picture in vdr-sxfe UI.
VDR says in its logfile that key binding must be done and that it goes into that mode.
However, I do not see that OSD for key learning in vdr-sxfe UI.

I guess it could be 2 issues here;
* VDR fails go into key learning mode.
or
* OSD is not shown in vdr-sxfe UI at all.

I suspec that latter, but I can't really verify it.

Anyone that has a way forward on this issue?
Could it be that there is a problem due to my FF cards?

I am currently running Gentoo and using VDR 1.6 from portage.

looking forward to some hints,

cheers,
lasso

Why is it always like this.

Many hours of testing and no success. Creating a post in the forum and 10 minutes afterwards I find the solution.

In my case it was that PrimaryDevice in setup.conf needed to be set to 2 instead of 1.
The reason why I got a picture on xinelibout but no OSD was probably due to the fact that I of some reason used --primary as input parameter.

I think everything works now, sorry for the posting.

cheers,
lasseo