Hallo,
bin mit meinem TV-Out der Geforce noch nicht ganz zufrieden. Links befindet sich noch ein ca. 1 cm breiter schwarzer Rand, das gesamte Bild ist nicht richtig zentriert. Die Manpages sagen folgendes:
ZitatModeLine "name" mode-description This entry is a more compact version of the Mode entry, and it also can be used to specify video modes for the monitor. is a single line format for specifying video modes. In most cases this isn't necessary because the built-in set of VESA standard modes will be sufficient. The mode-description is in four sections, the first three of which are mandatory. The first is the dot (pixel) clock. This is a single number specifying the pixel clock rate for the mode in MHz. The second section is a list of four numbers specifying the horizontal timings. These numbers are the hdisp, hsync- start, hsyncend, and htotal values. The third section is a list of four numbers specifying the vertical timings. These numbers are the vdisp, vsyncstart, vsyncend, and vtotal values. The final section is a list of flags specifying other characteris- tics of the mode. Interlace indicates that the mode is inter- laced. DoubleScan indicates a mode where each scanline is dou- bled. +HSync and -HSync can be used to select the polarity of the HSync signal. +VSync and -VSync can be used to select the polarity of the VSync signal. Composite can be used to specify composite sync on hardware where this is supported. Addition- ally, on some hardware, +CSync and -CSync may be used to select the composite sync polarity. The HSkew and VScan options men- tioned above in the Modes entry description can also be used here.
Damit bin ich leider überfordert. Wie muss ich an den Zahlen rumschrauben, um das Bild weiter nach Links zu rücken?
Grüsse,
Andreas