Kontron ktq87 RAM and XMP Profile , where is it in bios ?

    Hi,


    I have researched a long time on which RAM modules to install for kontron ktq87 board.


    This kit of 32 gb looks good :


    http://www.ebay.es/itm/Ballist…b8253e:g:ZLwAAOSwSYpZu8aX


    However, a question is in my mind. In my research it looks like this ram has to be modified in the bios to run at full speed which is 1600mhz; but the module on installing runs at 1333mhz. To change the speed you have to enable xmp profile. I went into the bios but can not find anything on xmp .Does the kontron board have this and if so may be you can show where it is.


    There is no memory tab or setting in the bios , which is strange.


    Many thanks.

    AVG2l : 1 x Kingston 120 gb ssd, 1 x seagate 4tb, 1 x toshiba 3tb
    VDR : 1.7.29.9
    IMAGE : BM2LTS v2.90
    Kontron ktq87 motherboard , i7-4770s Processor , Crucial 1600mhz 16gb ram , Internal netciever
    Using original avg2 frontpanel , COM port and Remote Control

    GPU : msi 1050 Ti 4gb Low Profile using Nvidia 384.130 proprietary driver


    I have also a KTQ87 (flex) in use, there is no option in the BiOS to configure memory.

    IMG_52441


    My memory, Crucial Ballistix VLP (4x8GB) BLS8G3D1609ES2LXO.16FER PC3-12800, work at 1600 Mhz without problems.


    My KTQM87 have the memory option ...

    IMG_52442

    easyVDR-1: DFi SD106, i3-7100T, PCIe Bifurcation: Asus NVIDIA GT 630 Rev. 2, & DD Octopus LE Bridge 2x DuoFlex v2, Noritake GU256x64D-3900B VFD , passiv gekühlt
    yaVDR2: Kontron KTQM67mITX, i7-3520M, 4GB DDR3, Asus NVIDIA GT 630 Rev. 2, Noritake GU256x64D-3900B VFD, SAT>IP
    easyVDR-2: bcm MX3150N, Pentium N3700, 4GB DDR3, ZOTAC GeForce GT 730 1x PCI-E, Sat>IP, Noritake GU256x64-372 VFD

    UP2VDR: UP Squared in Nexcom Nise 101 Gehäuse, Futaba VFD, passiv gekühlt
    SAT>iP: DD Octopus NET V2, Max A8, in Nexcom Nise 101 Gehäuse, semipassiv gekühlt

    Edited once, last by test.it ().

    Hi test.it,


    Many thanks for the ram you are using.


    That ram i am not able to locate . However, this ram


    http://www.ebay.es/itm/Ballist…b8253e:g:ZLwAAOSwSYpZu8aX


    Seems to be the same, just less latency.


    Ok, the lack of xmp profile with the ktq87 board is a shame.


    Many thanks again.

    AVG2l : 1 x Kingston 120 gb ssd, 1 x seagate 4tb, 1 x toshiba 3tb
    VDR : 1.7.29.9
    IMAGE : BM2LTS v2.90
    Kontron ktq87 motherboard , i7-4770s Processor , Crucial 1600mhz 16gb ram , Internal netciever
    Using original avg2 frontpanel , COM port and Remote Control

    GPU : msi 1050 Ti 4gb Low Profile using Nvidia 384.130 proprietary driver


Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login