EH (cnt=4)
[   26.159857] Linux video capture interface: v2.00
[   26.254997] powernow-k8: Found 1 AMD Athlon(tm) 64 X2 Dual Core Processor 3800+ processors (2 cpu cores) (version 2.00.00)
[   26.255227] powernow-k8:    0 : fid 0xc (2000 MHz), vid 0x8
[   26.255233] powernow-k8:    1 : fid 0xa (1800 MHz), vid 0xa
[   26.255237] powernow-k8:    2 : fid 0x2 (1000 MHz), vid 0x12
[   26.443936] saa7146: register extension 'dvb'.
[   26.446053] ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
[   26.446077] ACPI: PCI Interrupt 0000:05:06.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ 21
[   26.446208] saa7146: found saa7146 @ mem f92f0000 (revision 1, irq 21) (0x13c2,0x0000).
[   26.449662] ata1: soft resetting port
[   26.449669] ata1: SATA link down (SStatus 0 SControl 300)
[   26.449677] ata1: EH pending after completion, repeating EH (cnt=3)
[   26.449686] ata1: hard resetting port
[   26.478323] DVB: registering new adapter (Technotrend/Hauppauge WinTV DVB-S rev1.X or Fujitsu Siemens DVB-C)
[   26.494617] adapter has MAC addr = 00:d0:5c:1e:8d:4e
[   26.674121] dvb-ttpci: gpioirq unknown type=0 len=0
[   26.681781] dvb-ttpci: info @ card 0: firm f0240009, rtsl b0250018, vid 71010068, app 8000261d
[   26.681787] dvb-ttpci: firmware @ card 0 supports CI link layer interface
[   26.723953] ata1: SATA link down (SStatus 0 SControl 300)
[   26.723965] ata1: EH complete
[   26.731893] ata1: hard resetting port
[   26.764542] dvb-ttpci: adac type set to 0 @ card 0
[   26.766353] saa7146_vv: saa7146 (0): registered device video0 [v4l2]
[   26.768404] saa7146_vv: saa7146 (0): registered device vbi0 [v4l2]
[   26.795276] ves1x93: Detected ves1893a rev2
[   26.795283] DVB: registering frontend 0 (VLSI VES1x93 DVB-S)...
[   26.797210] input: DVB on-card IR receiver as /class/input/input3
[   26.797572] dvb-ttpci: found av7110-0.
[   26.814787] saa7146: register extension 'budget dvb'.
[   26.817092] ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
[   26.817106] ACPI: PCI Interrupt 0000:05:08.0[A] -> Link [APC3] -> GSI 18 (level, low) -> IRQ 22
[   26.817158] saa7146: found saa7146 @ mem f933a000 (revision 1, irq 22) (0x13c2,0x1003).
[   26.817165] saa7146 (1): dma buffer size 192512
[   26.817135] DVB: registering new adapter (TT-Budget/WinTV-NOVA-S  PCI)
[   26.833789] adapter has MAC addr = 00:d0:5c:21:0a:ed
[   27.005557] ata1: SATA link down (SStatus 0 SControl 300)
[   27.005567] ata1: EH pending after completion, repeating EH (cnt=4)
[   27.044402] DVB: registering frontend 1 (ST STV0299 DVB-S)...
[   27.072385] saa7146: register extension 'budget_ci dvb'.
[   27.084011] saa7146: register extension 'budget_av'.
[   27.095753] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
[   27.124563] cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded
[   27.126580] cx88[0]: subsystem: 0070:9202, board: Hauppauge Nova-S-Plus DVB-S [card=37,autodetected]
[   27.126588] cx88[0]: TV tuner type 4, Radio tuner type -1
[   27.250729] tveeprom 2-0050: Hauppauge model 92001, rev C1B1, serial# 3163888
[   27.250736] tveeprom 2-0050: MAC address is 00-0D-FE-30-46-F0
[   27.250741] tveeprom 2-0050: tuner model is Conexant_CX24109 (idx 111, type 4)
[   27.250747] tveeprom 2-0050: TV standards ATSC/DVB Digital (eeprom 0x80)
[   27.250817] tveeprom 2-0050: audio processor is CX883 (idx 32)
[   27.250819] tveeprom 2-0050: decoder processor is CX883 (idx 22)
[   27.250821] tveeprom 2-0050: has no radio, has IR receiver, has no IR transmitter
[   27.250823] cx88[0]: hauppauge eeprom: model=92001
[   27.251298] input: cx88 IR (Hauppauge Nova-S-Plus  as /class/input/input4
[   27.253005] cx88[0]/2: cx2388x 8802 Driver Manager
[   27.253132] ACPI: PCI Interrupt 0000:05:07.2[A] -> Link [APC2] -> GSI 17 (level, low) -> IRQ 20
[   27.253194] cx88[0]/2: found at 0000:05:07.2, rev: 5, irq: 20, latency: 32, mmio: 0xd4000000
[   27.259281] cx88/2: cx2388x dvb driver version 0.0.6 loaded
[   27.259288] cx88/2: registering cx8802 driver, type: dvb access: shared
[   27.259293] cx88[0]/2: subsystem: 0070:9202, board: Hauppauge Nova-S-Plus DVB-S [card=37]
[   27.259297] cx88[0]/2: cx2388x based DVB/ATSC card
[   27.278077] ata1: soft resetting port
[   27.278085] ata1: SATA link down (SStatus 0 SControl 300)
[   27.278093] ata1: EH complete
[   27.334351] ata2: hard resetting port
[   27.340258] ata1: hard resetting port
[   27.378095] DVB: registering new adapter (cx88[0])
[   27.378213] DVB: registering frontend 2 (Conexant CX24123/CX24109)...
[   27.405373] lirc_dev: IR Remote Control driver registered, major 61 
[   27.407815] lirc_serial: no version for "lirc_unregister_plugin" found: kernel tainted.
[   27.429291] skge eth0: Link is up at 100 Mbps, full duplex, flow control both
[   27.569835] ata2: SATA link down (SStatus 0 SControl 300)
[   27.569842] ata2: EH pending after completion, repeating EH (cnt=4)
[   27.573263] ata1: SATA link down (SStatus 0 SControl 300)
[   27.573271] ata1: EH complete
[   27.685722] Clocksource tsc unstable (delta = -181170400 ns)
[   27.709190] lirc_serial: auto-detected active high receiver
[   27.709194] lirc_dev: lirc_register_plugin: sample_rate: 0
[   27.721174] ata2: soft resetting port
[   27.721182] ata2: SATA link down (SStatus 0 SControl 300)
[   27.721189] ata2: EH pending after completion, repeating EH (cnt=3)
[   27.721203] ata2: hard resetting port
[   27.873586] ata2: SATA link down (SStatus 0 SControl 300)
[   27.873595] ata2: EH complete
[   27.882231] ata2: hard resetting port
[   28.034493] ata2: SATA link down (SStatus 0 SControl 300)
[   28.034501] ata2: EH pending after completion, repeating EH (cnt=4)
[   28.185902] ata2: soft resetting port
[   28.185908] ata2: SATA link down (SStatus 0 SControl 300)
[   28.185912] ata2: EH complete
[   28.299878] ata3: hard resetting port
[   28.603190] ata3: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[   28.607966] ata3.00: configured for UDMA/133
[   28.607973] ata3: EH pending after completion, repeating EH (cnt=4)
[   28.759145] ata3: soft resetting port
[   28.834600] ata3: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[   28.839357] ata3.00: configured for UDMA/133
[   28.839362] ata3: EH complete
[   28.839627] sd 2:0:0:0: [sda] 976773168 512-byte hardware sectors (500108 MB)
[   28.839641] sd 2:0:0:0: [sda] Write Protect is off
[   28.839643] sd 2:0:0:0: [sda] Mode Sense: 00 3a 00 00
[   28.839656] sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[   28.839671] sd 2:0:0:0: [sda] 976773168 512-byte hardware sectors (500108 MB)
[   28.839678] sd 2:0:0:0: [sda] Write Protect is off
[   28.839681] sd 2:0:0:0: [sda] Mode Sense: 00 3a 00 00
[   28.839692] sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[   28.964640] ata4: hard resetting port
[   29.267772] ata4: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[   29.286955] ata4.00: configured for UDMA/133
[   29.286961] ata4: EH pending after completion, repeating EH (cnt=4)
[   29.438238] ata4: soft resetting port
[   29.513697] ata4: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[   29.532811] ata4.00: configured for UDMA/133
[   29.532816] ata4: EH complete
[   29.533695] sd 3:0:0:0: [sdb] 1953525168 512-byte hardware sectors (1000205 MB)
[   29.533818] sd 3:0:0:0: [sdb] Write Protect is off
[   29.533866] sd 3:0:0:0: [sdb] Mode Sense: 00 3a 00 00
[   29.533926] sd 3:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[   29.533990] sd 3:0:0:0: [sdb] 1953525168 512-byte hardware sectors (1000205 MB)
[   29.534046] sd 3:0:0:0: [sdb] Write Protect is off
[   29.534091] sd 3:0:0:0: [sdb] Mode Sense: 00 3a 00 00
[   29.534179] sd 3:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA