detected
[   24.640327] usb 2-2: device not accepting address 2, error -71
[   25.259364] usb 5-6: new high speed USB device using ehci_hcd and address 3
[   25.361178] usb 5-6: device descriptor read/64, error -71
[   25.563850] usb 5-6: device descriptor read/64, error -71
[   25.766526] usb 5-6: new high speed USB device using ehci_hcd and address 4
[   25.868362] usb 5-6: device descriptor read/64, error -71
[   26.071037] usb 5-6: device descriptor read/64, error -71
[   26.273712] usb 5-6: new high speed USB device using ehci_hcd and address 5
[   26.675065] usb 5-6: device not accepting address 5, error -71
[   26.776906] usb 5-6: new high speed USB device using ehci_hcd and address 6
[   27.178258] usb 5-6: device not accepting address 6, error -71
[   27.383994] usbcore: registered new interface driver hiddev
[   27.640522] usb 2-2: new low speed USB device using uhci_hcd and address 4
[   27.816651] usb 2-2: configuration #1 chosen from 1 choice
[   28.048868] usb 4-2: new full speed USB device using uhci_hcd and address 2
[   28.220653] usb 4-2: configuration #1 chosen from 1 choice
[   28.267844] input: Twinhan Tech Remote Control as /class/input/input3
[   28.267883] input: USB HID v1.10 Keyboard [Twinhan Tech Remote Control] on usb-0000:00:1d.1-2
[   28.288529] input: Twinhan Tech Remote Control as /class/input/input4
[   28.289499] input: USB HID v1.10 Mouse [Twinhan Tech Remote Control] on usb-0000:00:1d.1-2
[   28.289527] usbcore: registered new interface driver usbhid
[   28.289532] drivers/usb/input/hid-core.c: v2.6:USB HID core driver
[   28.349298] EXT3 FS on hda1, internal journal
[   28.461217] kjournald starting.  Commit interval 5 seconds
[   28.461445] EXT3 FS on hda2, internal journal
[   28.461453] EXT3-fs: mounted filesystem with ordered data mode.
[   29.697499] 8139too Fast Ethernet driver 0.9.28
[   29.700799] ACPI: PCI Interrupt 0000:01:05.0[A] -> GSI 22 (level, low) -> IRQ 20
[   29.704480] eth0: RealTek RTL8139 at 0xf8cce800, 00:13:8f:f2:29:13, IRQ 20
[   29.704602] eth0:  Identified 8139 chip type 'RTL-8101'
[   29.769226] eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
[   30.170898] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
[   30.179021] flexcop-pci: will use the HW PID filter.
[   30.179148] flexcop-pci: card revision 2
[   30.179204] ACPI: PCI Interrupt 0000:01:01.0[A] -> GSI 22 (level, low) -> IRQ 20
[   30.182576] DVB: registering new adapter (FlexCop Digital TV device)
[   30.193532] b2c2-flexcop: MAC address = 00:d0:d7:0d:2d:9c
[   30.438159] b2c2-flexcop: found the stv0299 at i2c address: 0x68
[   30.438283] DVB: registering frontend 0 (ST STV0299 DVB-S)...
[   30.441487] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[   30.482589] saa7146: register extension 'budget dvb'.
[   30.536927] Linux video capture interface: v2.00
[   30.574733] saa7146: register extension 'budget_av'.
[   30.607378] saa7146: register extension 'budget_ci dvb'.
[   30.625063] saa7146: register extension 'dpc7146 demonstration board'.
[   30.658041] saa7146: register extension 'dvb'.
[   30.661331] ACPI: PCI Interrupt 0000:01:03.0[A] -> GSI 20 (level, low) -> IRQ 21
[   30.661499] saa7146: found saa7146 @ mem f8f04c00 (revision 1, irq 21) (0x13c2,0x0000).
[   30.721353] DVB: registering new adapter (Technotrend/Hauppauge WinTV DVB-S rev1.X or Fujitsu Siemens DVB-C)
[   30.742650] adapter has MAC addr = 00:d0:5c:03:b7:42
[   31.071116] dvb-ttpci: info @ card 1: firm f0240009, rtsl b0250018, vid 71010068, app 80f12623
[   31.071212] dvb-ttpci: firmware @ card 1 supports CI link layer interface
[   31.079160] dvb-ttpci: Crystal audio DAC @ card 1 detected
[   31.104765] saa7146_vv: saa7146 (0): registered device video0 [v4l2]
[   31.108058] saa7146_vv: saa7146 (0): registered device vbi0 [v4l2]
[   31.388310] DVB: registering frontend 1 (Philips TDA8083 DVB-S)...
[   31.394822] input: DVB on-card IR receiver as /class/input/input5
[   31.394967] dvb-ttpci: found av7110-0.
[   31.417218] saa7146: register extension 'hexium gemini'.
[   31.444889] saa7146: register extension 'hexium HV-PCI6 Orion'.
[   31.462668] saa7146: register extension 'Multimedia eXtension Board'.
[   31.595370] Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
[   31.841918] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
[   31.875108] lirc_dev: IR Remote Control driver registered, at major 61 
[   31.876359] lirc_serial: no version for "lirc_unregister_plugin" found: kernel tainted.
[   32.384934] lirc_serial: auto-detected active high receiver
[   32.384942] lirc_dev: lirc_register_plugin: sample_rate: 0
[   70.527340] ACPI: PCI interrupt for device 0000:01:01.0 disabled
[   70.534109] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip unloaded successfully
[   70.598679] saa7146: unregister extension 'budget dvb'.
[   70.667182] saa7146: unregister extension 'budget_av'.
[   70.700392] saa7146: unregister extension 'budget_ci dvb'.
[   70.722877] saa7146: unregister extension 'dpc7146 demonstration board'.
[   70.740663] saa7146: unregister extension 'dvb'.
[   70.806331] ACPI: PCI interrupt for device 0000:01:03.0 disabled
[   70.871828] saa7146: unregister extension 'hexium gemini'.
[   70.889109] saa7146: unregister extension 'hexium HV-PCI6 Orion'.
[   70.906872] saa7146: unregister extension 'Multimedia eXtension Board'.
[   80.036413] usbcore: registered new interface driver opera1
[   86.571833] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
[   86.579607] flexcop-pci: will use the HW PID filter.
[   86.579730] flexcop-pci: card revision 2
[   86.579786] ACPI: PCI Interrupt 0000:01:01.0[A] -> GSI 22 (level, low) -> IRQ 20
[   86.583195] DVB: registering new adapter (FlexCop Digital TV device)
[   86.594089] b2c2-flexcop: MAC address = 00:d0:d7:0d:2d:9c
[   86.820802] b2c2-flexcop: found the stv0299 at i2c address: 0x68
[   86.820925] DVB: registering frontend 0 (ST STV0299 DVB-S)...
[   86.824155] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[   86.853639] saa7146: register extension 'budget dvb'.
[   86.882260] Linux video capture interface: v2.00
[   86.898926] saa7146: register extension 'budget_av'.
[   86.922925] saa7146: register extension 'budget_ci dvb'.
[   86.937728] saa7146: register extension 'dpc7146 demonstration board'.
[   86.957910] saa7146: register extension 'dvb'.
[   86.961204] ACPI: PCI Interrupt 0000:01:03.0[A] -> GSI 20 (level, low) -> IRQ 21
[   86.961373] saa7146: found saa7146 @ mem f8f12c00 (revision 1, irq 21) (0x13c2,0x0000).
[   86.973846] DVB: registering new adapter (Technotrend/Hauppauge WinTV DVB-S rev1.X or Fujitsu Siemens DVB-C)
[   86.978075] adapter has MAC addr = 00:d0:5c:03:b7:42
[   87.306995] dvb-ttpci: info @ card 1: firm f0240009, rtsl b0250018, vid 71010068, app 80f12623
[   87.307088] dvb-ttpci: firmware @ card 1 supports CI link layer interface
[   87.315037] dvb-ttpci: Crystal audio DAC @ card 1 detected
[   87.340736] saa7146_vv: saa7146 (0): registered device video0 [v4l2]
[   87.343991] saa7146_vv: saa7146 (0): registered device vbi0 [v4l2]
[   87.612222] DVB: registering frontend 1 (Philips TDA8083 DVB-S)...
[   87.618447] input: DVB on-card IR receiver as /class/input/input6
[   87.618593] dvb-ttpci: found av7110-0.
[   87.631479] saa7146: register extension 'hexium gemini'.
[   87.646467] saa7146: register extension 'hexium HV-PCI6 Orion'.
[   87.661724] saa7146: register extension 'Multimedia eXtension Board'.
[   87.705379] lirc_dev: IR Remote Control driver registered, at major 61 
[   88.214464] lirc_serial: auto-detected active high receiver
[   88.214583] lirc_dev: lirc_register_plugin: sample_rate: 0