$ dmesg present. ACPI: RSDP (v000 SNI ) @ 0x000fe030 ACPI: RSDT (v001 SNI V66LT 0x00000001 Acer 0x00000000) @ 0x0fff0000 ACPI: FADT (v001 SNI V66LT 0x00000001 Acer 0x00000000) @ 0x0fff0028 ACPI: DSDT (v001 SNI V66LT 0x00001000 MSFT 0x0100000a) @ 0x00000000 Built 1 zonelists Kernel command line: vga=0x314 root=/dev/hda1 quiet aspi=force Initializing CPU#0 PID hash table entries: 1024 (order: 10, 16384 bytes) Detected 401.125 MHz processor. Using tsc for high-res timesource Console: colour dummy device 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 254976k/262080k available (2459k kernel code, 6540k reserved, 1217k data, 144k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 790.52 BogoMIPS (lpj=395264) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: After generic identify, caps: 0183f9ff 00000000 00000000 00000000 CPU: After vendor identify, caps: 0183f9ff 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After all inits, caps: 0183f9ff 00000000 00000000 00000040 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: Intel Pentium II (Deschutes) stepping 02 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. Checking for popad bug... OK. ACPI: IRQ9 SCI: Edge set to Level Trigger. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xf0200, last bus=1 PCI: Using configuration type 1 mtrr: v2.0 (20020519) ACPI: Subsystem revision 20040816 ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: PCI Interrupt Link [PILA] (IRQs 3 4 5 6 7 9 10 *11 12 14 15) ACPI: PCI Interrupt Link [PILB] (IRQs 3 4 5 6 7 9 *10 11 12 14 15) ACPI: PCI Interrupt Link [PILC] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled. ACPI: PCI Interrupt Link [PILD] (IRQs 3 4 5 *6 7 9 10 11 12 14 15) ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] Linux Plug and Play Support v0.97 (c) Adam Belay SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub PCI: Using ACPI for IRQ routing ACPI: PCI Interrupt Link [PILD] enabled at IRQ 6 ACPI: PCI interrupt 0000:00:07.2[D] -> GSI 6 (level, low) -> IRQ 6 ACPI: PCI Interrupt Link [PILA] enabled at IRQ 11 ACPI: PCI interrupt 0000:00:0e.0[A] -> GSI 11 (level, low) -> IRQ 11 ACPI: PCI Interrupt Link [PILB] enabled at IRQ 10 ACPI: PCI interrupt 0000:00:0f.0[A] -> GSI 10 (level, low) -> IRQ 10 ACPI: PCI interrupt 0000:00:10.0[A] -> GSI 6 (level, low) -> IRQ 6 devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x0 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). NTFS driver 2.1.20 [Flags: R/W]. Initializing Cryptographic API Limiting direct PCI/PCI transfers. vesafb: framebuffer at 0x81000000, mapped to 0xd0880000, size 1875k vesafb: mode is 800x600x16, linelength=1600, pages=3 vesafb: protected mode interface info at c000:4d13 vesafb: scrolling: redraw vesafb: Truecolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 100x37 fb0: VESA VGA frame buffer device ACPI: Power Button (FF) [PWRF] ACPI: Processor [CPU0] (supports C1 C2) isapnp: Scanning for PnP cards... isapnp: Card 'Crystal Codec' isapnp: 1 Plug & Play card detected total Real Time Clock Driver v1.12 serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 Using anticipatory io scheduler floppy0: no floppy controllers found loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 0000:00:07.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x9040-0x9047, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x9048-0x904f, BIOS settings: hdc:DMA, hdd:pio Probing IDE interface ide0... hda: SAMSUNG SV1604N, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: _NEC DVD_RW ND-2500A, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 Probing IDE interface ide2... ide2: Wait for ready failed before probe ! Probing IDE interface ide3... ide3: Wait for ready failed before probe ! Probing IDE interface ide4... ide4: Wait for ready failed before probe ! Probing IDE interface ide5... ide5: Wait for ready failed before probe ! hda: max request size: 1024KiB hda: 312581808 sectors (160041 MB) w/2048KiB Cache, CHS=19457/255/63, UDMA(33) hda: cache flushes supported /dev/ide/host0/bus0/target0/lun0: p1 hdc: ATAPI 40X DVD-ROM DVD-R CD-R/RW drive, 2048kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 usbcore: registered new driver aiptek drivers/usb/input/aiptek.c: v1.5 (May-15-2004): Bryan W. Headley/Chris Atenasio drivers/usb/input/aiptek.c: Aiptek HyperPen USB Tablet Driver (Linux 2.6.x) mice: PS/2 mouse device common for all mice input: AT Translated Set 2 keyboard on isa0060/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 16384) NET: Registered protocol family 1 NET: Registered protocol family 17 ACPI: (supports S0 S1 S5) ACPI wakeup devices: PCI0 USB0 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 144k freed EXT3 FS on hda1, internal journal cdfs 2.6.3a loaded. ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) USB Universal Host Controller Interface driver v2.2 PCI: Enabling device 0000:00:07.2 (0000 -> 0001) ACPI: PCI interrupt 0000:00:07.2[D] -> GSI 6 (level, low) -> IRQ 6 uhci_hcd 0000:00:07.2: Intel Corp. 82371AB/EB/MB PIIX4 USB uhci_hcd 0000:00:07.2: irq 6, io base 00001000 uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected Adding 262136k swap on /var/vm/swapfile. Priority:-1 extents:69 e100: Intel(R) PRO/100 Network Driver, 3.0.27-k2-NAPI e100: Copyright(c) 1999-2004 Intel Corporation ACPI: PCI interrupt 0000:00:10.0[A] -> GSI 6 (level, low) -> IRQ 6 e100: eth0: e100_probe: addr 0x82400000, irq 6, MAC addr 08:00:06:29:34:0F Linux video capture interface: v1.00 saa7146: register extension 'dvb'. ACPI: PCI interrupt 0000:00:0e.0[A] -> GSI 11 (level, low) -> IRQ 11 saa7146: found saa7146 @ mem d0b08000 (revision 1, irq 11) (0x13c2,0x0003). DVB: registering new adapter (Technotrend/Hauppauge WinTV Nexus-S rev2.X). adapter has MAC addr = 00:d0:5c:22:e5:a2 dvb-ttpci: gpioirq unknown type=0 len=0 dvb-ttpci: info @ card 0: firm f0240009, rtsl b0250018, vid 71010068, app 8000261c dvb-ttpci: firmware @ card 0 supports CI link layer interface dvb-ttpci: Crystal audio DAC @ card 0 detected saa7146_vv: saa7146 (0): registered device video0 [v4l2] DVB: registering frontend 0 (ST STV0299 DVB-S)... dvb-ttpci: found av7110-0. saa7146: register extension 'budget dvb'. saa7146: register extension 'budget_ci dvb'. ACPI: PCI interrupt 0000:00:0f.0[A] -> GSI 10 (level, low) -> IRQ 10 saa7146: found saa7146 @ mem d0b30400 (revision 1, irq 10) (0x13c2,0x100f). DVB: registering new adapter (TT-Budget/WinTV-NOVA-CI PCI). adapter has MAC addr = 00:d0:5c:23:8b:42 DVB: registering frontend 1 (ST STV0299 DVB-S)... saa7146: register extension 'budget dvb /w video in'. e100: eth0: e100_watchdog: link up, 100Mbps, full-duplex