Linux version 2.6.16 (Version:) (root@gustav) (gcc-Version 3.3.5 (Debian 1:3.3.5-13)) #1 Sat Nov 18 09:11:05 CET 2006 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000002fffd800 (usable) BIOS-e820: 000000002fffd800 - 000000002ffffc00 (ACPI data) BIOS-e820: 000000002ffffc00 - 0000000030000000 (ACPI NVS) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 767MB LOWMEM available. On node 0 totalpages: 196605 DMA zone: 4096 pages, LIFO batch:0 DMA32 zone: 0 pages, LIFO batch:0 Normal zone: 192509 pages, LIFO batch:31 HighMem zone: 0 pages, LIFO batch:0 DMI not present or invalid. ACPI: RSDP (v000 PTLTD ) @ 0x000f6d20 ACPI: RSDT (v001 PTLTD RSDT 0x00000001 PTL 0x01000000) @ 0x2fffdb26 ACPI: FADT (v001 FSC D1107 0x00000001 0x000f4240) @ 0x2fffdb4e ACPI: DSDT (v001 FSC D1107 0x00000001 MSFT 0x0100000c) @ 0x00000000 ACPI: PM-Timer IO Port: 0xf0c8 Allocating PCI resources starting at 40000000 (gap: 30000000:cfff0000) Built 1 zonelists Kernel command line: root=/dev/hda2 ro Local APIC disabled by BIOS -- you can enable it with "lapic" mapped APIC to ffffd000 (01603000) Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 4096 (order: 12, 65536 bytes) Detected 498.628 MHz processor. Using pmtmr for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 775176k/786420k available (1537k kernel code, 10672k reserved, 657k data, 232k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 997.97 BogoMIPS (lpj=498985) Security Framework v1.0.0 initialized SELinux: Disabled at boot. Mount-cache hash table entries: 512 CPU: After generic identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000 CPU: Intel Pentium III (Katmai) stepping 03 Checking 'hlt' instruction... OK. ACPI: setting ELCR to 0200 (from 0e00) checking if image is initramfs... it is Freeing initrd memory: 989k freed NET: Registered protocol family 16 EISA bus registered ACPI: bus type pci registered PCI: PCI BIOS revision 2.10 entry at 0xfd994, last bus=1 PCI: Using configuration type 1 ACPI: Subsystem revision 20060127 ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (0000:00) PCI: Probing PCI hardware (bus 00) ACPI: Assume root bridge [\_SB_.PCI0] bus is 0 PCI quirk: region f0c0-f0ff claimed by PIIX4 ACPI PCI quirk: region f0b0-f0bf claimed by PIIX4 SMB Boot video device is 0000:00:12.0 ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCI1._PRT] ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 9 10 *11 12 14 15) ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 9 *10 11 12 14 15) ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 *9 10 11 12 14 15) ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 6 7 *9 10 11 12 14 15) ACPI: Device [PS2M] status [00000008]: functional but not present; setting present ACPI: Device [ECP] status [00000008]: functional but not present; setting present Linux Plug and Play Support v0.97 (c) Adam Belay pnp: PnP ACPI init pnp: PnP ACPI: found 11 devices PnPBIOS: Disabled by ACPI PNP PCI: Using ACPI for IRQ routing PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report PCI: Bridge: 0000:00:01.0 IO window: disabled. MEM window: disabled. PREFETCH window: disabled. audit: initializing netlink socket (disabled) audit(1165172186.921:1): initialized VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered Limiting direct PCI/PCI transfers. isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found PNP: PS/2 Controller [PNP0303:KEYB] at 0x60,0x64 irq 1 PNP: PS/2 controller doesn't have AUX irq; using default 12 serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A 00:09: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A 00:0a: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize EISA: Probing bus 0 at eisa.0 Cannot allocate resource for EISA slot 7 EISA: Detected 0 cards. NET: Registered protocol family 2 IP route cache hash table entries: 32768 (order: 5, 131072 bytes) TCP established hash table entries: 131072 (order: 7, 524288 bytes) TCP bind hash table entries: 65536 (order: 6, 262144 bytes) TCP: Hash tables configured (established 131072 bind 65536) TCP reno registered TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 8 NET: Registered protocol family 20 Using IPI Shortcut mode ACPI wakeup devices: PCI0 PCI1 USB KEYB PS2M COM1 COM2 ACPI: (supports S0 S1 S3 S4 S5) Freeing unused kernel memory: 232k freed mice: PS/2 mouse device common for all mice Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 0000:00:07.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x7cf0-0x7cf7, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0x7cf8-0x7cff, BIOS settings: hdc:DMA, hdd:pio Probing IDE interface ide0... input: AT Translated Set 2 keyboard as /class/input/input0 hda: ST315323A, ATA DISK drive hdb: ST3250823A, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: CW089D ATAPI CD-R/RW, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 hda: max request size: 128KiB hda: 30008475 sectors (15364 MB) w/512KiB Cache, CHS=29770/16/63, UDMA(33) hda: cache flushes not supported hda: hda1 hda2 hdb: max request size: 512KiB hdb: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63, UDMA(33) hdb: cache flushes supported hdb: hdb1 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. Adding 265032k swap on /dev/hda1. Priority:-1 extents:1 across:265032k EXT3 FS on hda2, internal journal Real Time Clock Driver v1.12ac Generic RTC Driver v1.07 parport: PnPBIOS parport detected. parport0: PC-style at 0x278, irq 5 [PCSPP,TRISTATE,EPP] CAPI Subsystem Rev 1.1.2.8 b1: revision 1.1.2.2 b1isa: revision 1.1.2.3 CSLIP: code copyright 1989 Regents of the University of California ISDN subsystem Rev: 1.1.2.3/1.1.2.3/1.1.2.2/1.1.2.3/1.1.2.2/1.1.2.2 loaded capidrv: Rev 1.1.2.2: loaded e100: Intel(R) PRO/100 Network Driver, 3.5.10-k2-NAPI e100: Copyright(c) 1999-2005 Intel Corporation ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 9 PCI: setting IRQ 9 as level-triggered ACPI: PCI Interrupt 0000:00:0d.0[A] -> Link [LNKD] -> GSI 9 (level, low) -> IRQ 9 e100: eth0: e100_probe: addr 0xfedfa000, irq 9, MAC addr 00:30:05:05:AE:66 device-mapper: 4.5.0-ioctl (2005-10-04) initialised: dm-devel@redhat.com kjournald starting. Commit interval 5 seconds EXT3 FS on hdb1, internal journal EXT3-fs: mounted filesystem with ordered data mode. e100: eth0: e100_watchdog: link up, 100Mbps, half-duplex ttyS3: LSR safety check engaged! ttyS3: LSR safety check engaged! NET: Registered protocol family 10 lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver capifs: Rev 1.1.2.3 capi20: Rev 1.1.2.7: started up with major 68 (middleware+capifs) b1isa: NO card at 0x150 (1) b1isa: NO card at 0x150 (1) b1isa: NO card at 0x150 (1) b1isa: NO card at 0x150 (1) eth0: no IPv6 routers present ACPI: Power Button (FF) [PWRF] ACPI: Power Button (CM) [PWRB] dazuko: loaded, version=2.3.1 process `cyrmaster' is using obsolete setsockopt SO_BSDCOMPAT lp0: using parport0 (interrupt-driven). usbcore: registered new driver usbfs usbcore: registered new driver hub NET: Registered protocol family 9 X.25 for Linux. Version 0.2 for Linux 2.1.15 Linux video capture interface: v1.00 saa7146: register extension 'dvb'. Installing knfsd (copyright (C) 1996 okir@monad.swb.de). NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory NFSD: unable to find recovery directory /var/lib/nfs/v4recovery NFSD: starting 90-second grace period hdc: ATAPI 24X CD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 ISO 9660 Extensions: Microsoft Joliet Level 3 ISO 9660 Extensions: RRIP_1991A ISO 9660 Extensions: Microsoft Joliet Level 3 ISO 9660 Extensions: RRIP_1991A ISO 9660 Extensions: Microsoft Joliet Level 3 ISO 9660 Extensions: RRIP_1991A