Hallo,
habe hier 2 Platinen der früheren Sammelbestellung mit der Firmware, die ich damals für alle geflasht habe.
Beide Platinen sind so eingestellt, das die eine Platine links und rechts darstellen soll und die 2. Platine ist nur für den oben Bildinhalt da.
Dies ist über die Jumper so eingestellt wie in der Wiki angegeben.
Wenn ich nun in den Plugineinstellungen die statische Farbe für die einzellnen Kanäle einstelle, dann werden alle Farben korrekt angezeigt.(auch oben alle 3 Farben)
ABER
Wenn ich in den Einstellungen auf Livebild umschalte, dann werden nur die beiden Seiten mit Informationen "versorgt" und die 2. Platine(oberer Bildinhalt) bleibt dunkel.
Hier mal meine Einstellungen der setup.conf
Code
atmo.BrightnessCorrection = 300
atmo.DarknessLimit = 4
atmo.DefaultColor = 1
atmo.EdgeWeighting = 5
atmo.Filter_MeanLength = 500
atmo.Filter_MeanThreshold = 50
atmo.Filter_Mode = 1
atmo.Filter_PercentNew = 80
atmo.Gamma_Blue = 10
atmo.Gamma_Green = 10
atmo.Gamma_Mode = 0
atmo.Gamma_Red = 10
atmo.HueWindowSize = 4
atmo.Mode = 0
atmo.SatWindowSize = 4
atmo.Startmode = 1
atmo.StaticColor_Bottom_B = 0
atmo.StaticColor_Bottom_G = 0
atmo.StaticColor_Bottom_R = 0
atmo.StaticColor_Center_B = 0
atmo.StaticColor_Center_G = 0
atmo.StaticColor_Center_R = 0
atmo.StaticColor_Left_B = 0
atmo.StaticColor_Left_G = 0
atmo.StaticColor_Left_R = 0
atmo.StaticColor_Right_B = 0
atmo.StaticColor_Right_G = 0
atmo.StaticColor_Right_R = 0
atmo.StaticColor_Top_B = 0
atmo.StaticColor_Top_G = 0
atmo.StaticColor_Top_R = 0
atmo.White_Calibration_Blue = 230
atmo.White_Calibration_Blue2 = 0
atmo.White_Calibration_Green = 208
atmo.White_Calibration_Green2 = 0
atmo.White_Calibration_Red = 208
atmo.White_Calibration_Red2 = 0
atmo.WidescreenMode = 1
Display More
Woran kann das liegen?
Gruß
Papsi