Hallo Zusammen,
ich habe zwei Samsung Festplatten vom Typ HD300LD in meinem VDR verbaut.
Ich möchte dass beim Einschalten meines Rechners, die zweite Platte nicht hochfährt.
Die Platte unterstützt laut "hdparm -I /dev/hdb"
das Feature "Power-Up In Standby feature set"
Jedoch ist die Funktion deaktiviert. (vergleiche Zeile 42)
Kann mir jemand sagen wie ich diese Funktion aktivieren kann.
gruss geordie
Code
non-removable ATA device, with non-removable media
Model Number: SAMSUNG HD300LD
Serial Number: S0A4J1TL650425
Firmware Revision: WK100-12
Standards:
Supported: 1 2 3 4 5 6 7
Likely used: 7
Configuration:
Logical max current
cylinders 16383 65535
heads 16 1
sectors/track 63 63
bytes/track: 34902 (obsolete)
bytes/sector: 554 (obsolete)
current sector capacity: 4128705
LBA user addressable sectors = 268435455
Capabilities:
LBA, IORDY(can be disabled)
Buffer size: 8192.0kB ECC bytes: 4 Queue depth: 1
Standby timer values: spec'd by standard, no device specific minimum
r/w multiple sector transfer: Max = 16 Current = 16
DMA: mdma0 mdma1 mdma2 udma0 udma1 *udma2 udma3 udma4 udma5
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* NOP cmd
* READ BUFFER cmd
* WRITE BUFFER cmd
* Host Protected Area feature set
* look-ahead
* write cache
* Power Management feature set
Security Mode feature set
SMART feature set
SET MAX security extension
SET FEATURES subcommand required to spinup after power up
Power-Up In Standby feature set
* DOWNLOAD MICROCODE cmd
Security:
Master password revision code = 65534
supported
not enabled
not locked
not frozen
not expired: security count
supported: enhanced erase
228min for SECURITY ERASE UNIT. 228min for ENHANCED SECURITY ERASE UNIT.
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
Checksum: correct