Hallo Leute,
nach dem Übersetzen des Treibers bekomme ich den Fehler: Unknown symbol in module
vdr01 vdr-1.7.16 # modinfo saa716x_ff
filename: /lib/modules/2.6.35-gentoo-r12/kernel/drivers/media/common/saa716x/saa716x_ff.ko
license: GPL
author: Manu Abraham
description: SAA716x FF driver
alias: pci:v00001131d00007160sv000013C2sd0000300Abc*sc*i*
alias: pci:v00001131d00007160sv000013C2sd00003009bc*sc*i*
depends: dvb-core,saa716x_core
vermagic: 2.6.35-gentoo-r12 SMP preempt mod_unload modversions PENTIUMIII
parm: verbose:verbose startup messages, default is 1 (yes) (int)
parm: int_type:force Interrupt Handler type: 0=INT-A, 1=MSI, 2=MSI-X. default INT-A mode (int)
vdr01 vdr-1.7.16 # modprobe saa716x_ff
FATAL: Error inserting saa716x_ff (/lib/modules/2.6.35-gentoo-r12/kernel/drivers/media/common/saa716x/saa716x_ff.ko): Unknown symbol in module, or unknown parameter (see dmesg)
vdr01 vdr-1.7.16 #
Ich habe mich nach http://www.vdr-wiki.de/wiki/in…end_S2-6400_-_DVB_Treiber gerichtet.
dmesg:
saa7146: register extension 'dvb'.
dvb 0000:05:05.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20
saa7146: found saa7146 @ mem e234cc00 (revision 1, irq 20) (0x13c2,0x0000).
DVB: registering new adapter (Technotrend/Hauppauge WinTV DVB-S rev1.X or Fujitsu Siemens DVB-C)
adapter has MAC addr = 00:d0:5c:00:b9:7e
dvb-ttpci: gpioirq unknown type=0 len=0
dvb-ttpci: info @ card 0: firm f0240009, rtsl b0250018, vid 71010068, app 8000261d
dvb-ttpci: firmware @ card 0 supports CI link layer interface
dvb-ttpci: adac type set to 0 @ card 0
saa7146_vv: saa7146 (0): registered device video0 [v4l2]
saa7146_vv: saa7146 (0): registered device vbi0 [v4l2]
ves1x93: Detected ves1893a rev2
DVB: registering adapter 0 frontend 0 (VLSI VES1x93 DVB-S)...
input: DVB on-card IR receiver as /devices/pci0000:00/0000:00:06.0/0000:05:05.0/input/input6
dvb-ttpci: found av7110-0.
Was stimmt da nicht?