Ok I'm useing gen2vdr v2.0 w/VDR-1.7.0-ext-62 w/a KNC-1 TV-Station (DVB-C), TT S2-300 (DVB-S/S2)* and I'm using the Reel-eHD as an Output Device.
Now to my problem; I hope someone here could possibly give me some tips on how to fix this...
Ok now every time I either (cold)start or restart VDR, everything thankfully boots up fine w/o any errors.
But in order to use VDR I'm forced to reset my Output Device.
Which is already correctly set [to "3"] DVB-C + TT S-3200 = eHD @ 3.
But, all I get is a Black Screen w/no audio.
If I do a:
Setup->DVB->Primary DVB=(press left) ~then~
Setup->DVB->Primary DVB=(press right)
Essentially forcing Output Device to 2 and then back to 3, before I get "Light".
Is there something I can do (or change in a *.conf) file to eliminate myself from having to do this every time??
Thanks
*I'm using the Liplianindvb Driver, not that I'm having better results w/Multiproto. Because I don't, Multiproto fails to lock on most of the Transponders on Astra2/€urobird1 (28.2°E/28.5°E).
Where Liplianindvb Drivers do work!