Hi,
soweit die Meldungen von dmesg:
ZitatAlles anzeigenscsi 4:0:0:0: Direct-Access USB2.0 Flash Disk 2.10 PQ: 0 ANSI: 2
sd 4:0:0:0: [sdd] 8388608 512-byte hardware sectors (4295 MB)
sd 4:0:0:0: [sdd] Write Protect is off
sd 4:0:0:0: [sdd] Mode Sense: 0b 00 00 08
sd 4:0:0:0: [sdd] Assuming drive cache: write through
sd 4:0:0:0: [sdd] 8388608 512-byte hardware sectors (4295 MB)
sd 4:0:0:0: [sdd] Write Protect is off
sd 4:0:0:0: [sdd] Mode Sense: 0b 00 00 08
sd 4:0:0:0: [sdd] Assuming drive cache: write through
sdd: unknown partition table
sd 4:0:0:0: [sdd] Attached SCSI removable disk
sd 4:0:0:0: Attached scsi generic sg4 type 0
usb-storage: device scan complete
...
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
...
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
sd 4:0:0:0: [sdd] Result: hostbyte=DID_ABORT driverbyte=DRIVER_OK,SUGGEST_OK
end_request: I/O error, dev sdd, sector 8388480
Buffer I/O error on device sdd, logical block 1048560
...
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
end_request: I/O error, dev fd0, sector 0
end_request: I/O error, dev fd0, sector 0
usb 2-1.4: reset high speed USB device using ehci_hcd and address 3
Unter win funktioniert er 
Was könnte ich probieren um ihn zum laufen zu bewegen?