hallo zusammen
ich hab hier ne skystar2 und weiß grad nicht warum sie nicht läuft.
ich mache ein modprobe b2c2_flexcop_pci
dmesg liefert:
Code
b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
PCI: Enabling device 0000:00:09.0 (0000 -> 0003)
ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKD] -> GSI 5 (level, low) -> IRQ 5
DVB: registering new adapter (FlexCop Digital TV device).
b2c2-flexcop: MAC address = 00:d0:d7:12:22:af
i2c_adapter i2c-0: SMBus Quick command not supported, can't probe for chips
b2c2-flexcop: found the stv0299 at i2c address: 0x68
DVB: registering frontend 0 (ST STV0299 DVB-S)...
b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
Alles anzeigen
wenn ich jetzt aber mal versuche nen channel scan zu machen:
Code
scanning test
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
initial transponder 11953500 H 27500000 3
>>> tune to: 11953:h:0:27500
WARNING: >>> tuning failed!!!
>>> tune to: 11953:h:0:27500 (tuning failed)
WARNING: >>> tuning failed!!!
ERROR: initial tuning failed
dumping lists (0 services)
Done.
vdr läuft natürlich bei diesem versuch nicht.
wonach muss ich suchen?
vielen dank und grüße
atosch