multiplex streams

driesgeentjens_9@hotmail.com is my email-adres

Thanks in advance

Regards

While i was waiting for the link that shmirl is going to send me,
i already tried some stuff and i think i found a quiet new source-code
for the vdr-steam-plugin. It's called vdr-streamdev-0.3.1.tgz.
There where a few links and i downloaded the source-code from every
link and i tried to install all these codes. But everytime when i tried, i
received the same error:

Plugin streamdev:
make[1]: Entering directory `/usr/local/src/VDR/PLUGINS/src/streamdev'
make[1]: Leaving directory `/usr/local/src/VDR/PLUGINS/src/streamdev'
make[1]: Entering directory `/usr/local/src/VDR/PLUGINS/src/streamdev'
g++ -W -Woverloaded-virtual -O2 -c -D_GNU_SOURCE -DHAVE_AUTOPID -I../../../include -I../../../../DVB/include -I. -o streamdev-server.o streamdev-server.c
streamdev-server.h:22: error: conflicting return type specified for 'virtual bool cPluginStreamdevServer::Active()'
../../../include/vdr/plugin.h:43: error: overriding 'virtual cString cPlugin::Active()'
make[1]: *** [streamdev-server.o] Error 1
make[1]: Leaving directory `/usr/local/src/VDR/PLUGINS/src/streamdev'

So, i thougt that this was because off a missing variable on my system but i really don't know. It's just a idea. And i' am afraid the code that shmirl is going to send me will do the same think.

Regards

schmirl, i still didn't receive your email.
Maybe you should try to send it this mail-adres:
dries.geentjens@edu.khk.be
This should work properly:-)

Best Regards

Hey,

i finally received schmirl's mail with the link and
the plugin worked. Thanks a lot, you helped me
a lot. Now i can stream a hole MPEG TS and that's a
good thing.

Best Regards

When i start the vdr-streamdev-server,
i also would like to choose with channels-group the server
has to stream(because there are 3 groups)
Is there anybody who knows how i should do this?

Best Regards

At the moment i'am using this command to start my server:
vdr -P"xineliboutput" -Pstreamdev-server
and it works properly.
But i only have one tuner one the card so there's only one transponder
that is streamed over the network. The default one.
Now my question is how i could choose between transponders in the
command?
After this, i' am going to put my sever in third run-level
and than i have to know the command for placing it into crontab.

Best Regards

Thanks,

that's very good and it works because i already tried
but the thing i need is something else. I have three cards
and my server runs in level 3.
When the server boots, it should start three vdr-applications.
with the server-plugin.
Every application should use a different card and every card
should be tuned to a different transponder. So i can stream every
channel in the same time.
I was planning to use three cards because there a three different
transponders.
Now i need three commands for crontab that brings me this
configuration?
I hope that you understood my thoughts. It's not so easy to explain:-)

Cheers

So actually,

i just have to put the three cards in my system. Make sure that
all the three cards are supported and start vdr with the vdr-streamdev-server-plugin. Vdr automatically makes sure that two different clientcan watch channels in different transponders without problems?!
That would be wonderfull!!!!! I will try this tomorrow.

Cheers