Hallo,
Mein VDR läuft jetzt soweit, DVB usw. alles ok 
Bei S-Video / Composite Eingang bleibt das Bild schwarz, ton über Line in aber da.
Bild über HF (Antennen) Eingang ist auch da und läuft somit.
Wo könnte das Problem liegen?
VDR:
PVR350
Nexus 2.3
2000+ AMD
256MB RAM
LinVDR 0.7 - patched 1.4.0 - neuste Version
Bild funktioniert 1A über HF, nur über S-Video / Composite IN = Bild Schwarz 
Channels.conf - pvrinput teil:
k34;w_pvrscan:575250:B6C12D45:C:0:301:300:305:A1:9204:0:0:0
Composite 0;w_pvrscan:1:B6C12D0:C:0:301:300:305:A1:9000:0:0:0
Composite 1;w_pvrscan:1:B6C12D12:C:0:301:300:305:A1:9001:0:0:0
Composite 2;w_pvrscan:1:B6C12D23:C:0:301:300:305:A1:9002:0:0:0
Composite 3;w_pvrscan:1:B6C12D34:C:0:301:300:305:A1:9003:0:0:0
Composite 4;w_pvrscan:1:B6C12D56:C:0:301:300:305:A1:9005:0:0:0
S-Video 0;w_pvrscan:1:B6C12D67:C:0:301:300:305:A1:9006:0:0:0
S-Video 1;w_pvrscan:1:B6C12D78:C:0:301:300:305:A1:9007:0:0:0
S-Video 2;w_pvrscan:1:B6C12D89:C:0:301:300:305:A1:9008:0:0:0
S-Video 3;w_pvrscan:1:B6C12D89:C:0:301:300:305:A1:9009:0:0:0
k34 = der funktionierende Sender, wo ich auch ohne Probleme ein Bild bekomme.
Die restlichen Eingänge sind tot?
ivtv Version: 0.4.5
Dr. Seltsam kernel 2.6.15
ivtv output:
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.5 (development snapshot compiled on Sa 29 Apr 2006 14:18:46 CEST) loading
ivtv: Linux version: 2.6.15 386 gcc-3.3
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected WinTV PVR 350 card (cx23415 based)
ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
ACPI: PCI Interrupt 0000:01:06.0[A] -> Link [APC3] -> GSI 18 (level, high) -> IRQ 209
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
tveeprom 1-0050: Hauppauge model 48139, rev K257, serial# 7980334
tveeprom 1-0050: tuner model is Philips FM1216 ME MK3 (idx 57, type 38)
tveeprom 1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
tveeprom 1-0050: audio processor is MSP4418 (idx 25)
tveeprom 1-0050: decoder processor is SAA7115 (idx 19)
tveeprom 1-0050: has radio, has IR remote
tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
eth0: link up.
saa7115 1-0021: ivtv driver
saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21]
saa7127 1-0044: ivtv driver
saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7127, addr=44]
msp3400 1-0040: ivtv driver
msp3400 1-0040: chip=MSP4418G-B3 +nicam +simple +simpler +radio mode=simpler
ivtv0: i2c attach to card #0 ok [client=MSP4418G-B3, addr=40]
msp3400 1-0040: msp34xxg daemon started
tda9887 1-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Decoder revision: 0x02020023
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total)
ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total)
ivtv0: Create decoder VOUT stream
ivtv0: Allocate DMA decoder YUV stream: 20 x 51840 buffers (1024KB total)
ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)
tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by ivtv i2c driver #0
ivtv0: Initialized WinTV PVR 350, card #0
ivtv: ==================== END INIT IVTV ====================
Mfg,
P2k1
