I did an upgrade first to Linvdr0.6 to 0.7 but found that my channels.conf caused the blank screen reseting. Havind deleted my terestrial channels a picture from Astra 19.2 was seen.
I next went in via the console and stopped vdr to do a channel scan. I then noticed that I could see channels from the first frequency only. All other channels came up with tuning failed on terestrial.
At this point I did a fresh install of 0.7. I copied in my channels.conf and diseqc.conf and I got a picture from the nova-t and dvb-s. Changing channels on the DVB-s was fine; but, using nova-t channels I found I had to wait 5 seconds for the red indicator and EPG to appear. But no picture and sound even if I waited 20mins. I could get picture and sound if I changed to another Terestrial channel waited for the EPG and then pressed the same channel number again!!
As before I went in via the console and tried a teresetrial scan again only the first transponder found channels the rest said tuning failed.
For this scan I did the following:-
#/etc/init.d/runvdr stop
#/etc/init.d/runvdr loaddriver
#scan -i 0 -a 1 -o vdr -p Ox.ini>>ter.conf
Ox.ini contain whats stored lower down in the /etc/vdr/scan directory
my nova-t is adaptor 1.
I also copied the older firmware from 0.6 to replace the tda10045 version but that didn't work, so I guess its not the same any more.
Anyone else experienced this same behaviour or have some idea how to fix the problem ?
I have had to abandon 0.7 and reloaded 0.6 which work fine and scan's properly and changes channel in less than 1 second.
My hardware:-
Asus Pundit with 512MB and P4 2.8GHz
sony DRU510A DVD+/-R/RW,CD-R/RW
maxtor diamond max 9 160G
DVB-S 1.6 and Nova-T-ci(tda10045 frontend)