ngene: error in i2c_read_reg beim booten

Hallo,

habe folgende Fehlermeldung beim booten:

Zitat

messages:Dec 11 19:43:08 [kernel] EXT3-fs (sda2): using internal journal
messages:Dec 11 19:43:08 [kernel] nGene PCIE bridge driver, Copyright (C) 2005-2007 Micronas
messages:Dec 11 19:43:08 [kernel] ACPI: PCI Interrupt Link [LN0A] enabled at IRQ 19
messages:Dec 11 19:43:08 [kernel] ngene 0000:02:00.0: PCI INT A -> Link[LN0A] -> GSI 19 (level, low) -> IRQ 19
messages:Dec 11 19:43:08 [kernel] ngene: Found Linux4Media cineS2 DVB-S2 Twin Tuner (v5)
messages:Dec 11 19:43:08 [kernel] ngene: Device version 1
messages:Dec 11 19:43:08 [kernel] ngene: Loading firmware file ngene_18.fw.
messages:Dec 11 19:43:08 [kernel] error in i2c_read_reg
messages:Dec 11 19:43:08 [kernel] No CXD2099 detected at 40
messages:Dec 11 19:43:08 [kernel] DVB: registering new adapter (nGene)
messages:Dec 11 19:43:08 [kernel] LNBx2x attached on addr=a
messages:Dec 11 19:43:08 [kernel] stv6110x_attach: Attaching STV6110x
messages:Dec 11 19:43:08 [kernel] DVB: registering adapter 0 frontend 0 (STV090x Multistandard)...
messages:Dec 11 19:43:08 [kernel] LNBx2x attached on addr=8
messages:Dec 11 19:43:08 [kernel] stv6110x_attach: Attaching STV6110x
messages:Dec 11 19:43:08 [kernel] DVB: registering adapter 0 frontend 0 (STV090x Multistandard)...
messages:Dec 11 19:43:08 [kernel] forcedeth: Reverse Engineered nForce ethernet driver. Version 0.64.
messages:Dec 11 19:43:08 [kernel] ACPI: PCI Interrupt Link [LMAC] enabled at IRQ 21

Alles anzeigen

Wie bekommt man das "error in i2c_read_reg" gelöst?

Als Treiber nutze ich den aktuelle test2 von Ufo.

Viele Grüße
kaminkehrer

DNAKE!!!