nova-t 500 remote only works on cold boot, not after reboot

Output of cat /proc/bus/input/device is attached. The output is the same for both cold and warm boot.

Zitat von seahawk1986

Hi,
I found this thread yavdr 4.0; grey hauppauge remote on nova-t 500
Probably you were absolutely right it's a driver related issue - but it seems it existed with v4l-dvb-dkms already.
Are there any hints within the output of dmesg if there is a problem loading the firmware?

It appears that the only significant difference is the line "dib0700: rc submit urb failed"

A google search turns up a few other people with the same problem, but no apparent solution. Am wondering if some recent dib0700 cleanups would possibly fix the issue? See eg. http://patchwork.linuxtv.org/patch/9858/

I assume there's no way to run more recent kernels except using the test repositories?

Zitat von seahawk1986

There are two other recognized IR-receivers attached to your VDR - probably you could use them, too.

Well, there's one additional nova-t 500 card with the same problem, and the driver for the other, a c1501 dvb-c card doesn't implement generic RC-5 reception as the nova-t 500 does.

Probably relevant as well; https://lists.linux-foundation…/2010-October/025769.html

Zitat von seahawk1986

What protocols are supported by this card?

Code

sudo ir-keytable

root@htpc2:~# ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event2) with:
Driver budget_ci, table rc-tt-1500
Supported protocols:
Enabled protocols:
Repeat delay = 500 ms, repeat period = 125 ms
Found /sys/class/rc/rc1/ (/dev/input/event3) with:
Driver (null), table rc-dib0700-rc5
Supported protocols: NEC RC-5 RC-6
Enabled protocols: RC-5
Repeat delay = 500 ms, repeat period = 125 ms
Found /sys/class/rc/rc2/ (/dev/input/event4) with:
Driver (null), table rc-dib0700-rc5
Supported protocols: NEC RC-5 RC-6
Enabled protocols: RC-5
Repeat delay = 500 ms, repeat period = 125 ms