The Netceiver with VLAN does not seem to work in yavdr 0.4.0

The netceiver works without any problem when I connect it directly to eth0.

As soon as I install vlan and configure the vlan switch where the netceiver connects to eth0.2 and the internet to eth0.1 everything slows down.
- The yavdr client is very slow over ssh.
- All the sat channels jumps and pixcelates.
- Internet is very very very slow.

3 other clients works perfectly with yavdr 0.3.

/etc/network/interfaces
---------------------------------------------------------
auto lo
iface lo inet loopback
address 127.0.0.1
netmask 255.0.0.0

auto eth0
iface eth0 inet static
address 192.168.0.103
netmask 255.255.255.0
gateway 192.168.0.2

auto eth0.2
iface eth0.2 inet static
address 10.0.0.4
netmask 255.255.255.0
vlan_raw_device eth0

----------------------------------

My ifconfig reads:

----------------------------------
eth0 Link encap:Ethernet HWaddr 00:01:2e:27:64:d8
inet addr:192.168.0.103 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::201:2eff:fe27:64d8/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5154885 errors:1 dropped:179 overruns:0 frame:1
TX packets:14151 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4821081143 (4.8 GB) TX bytes:2530681 (2.5 MB)
Interrupt:21 Base address:0xc000

eth0.2 Link encap:Ethernet HWaddr 00:01:2e:27:64:d8
inet6 addr: fe80::201:2eff:fe27:64d8/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5152184 errors:0 dropped:0 overruns:0 frame:0
TX packets:12501 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4748273984 (4.7 GB) TX bytes:2218678 (2.2 MB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:135 errors:0 dropped:0 overruns:0 frame:0
TX packets:135 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10682 (10.6 KB) TX bytes:10682 (10.6 KB)
----------------------------------------------------------------------------------------------------

I also read the following article that might be the reason for my problem, but I'm not sure! :

[Bug 771209] Re: VLANs no longer work with bridges in natty

Zitat

Apparently this is known in VLAN and bridging;

http://permalink.gmane.org/gmane.lin...rk.bridge/5362

The (short term?) fix would be to install ebtables, and the run the

command;

ebtables -t broute -A BROUTING -i eth0 -p 802_1Q -j DROP

This got my interfaces bridging with VLAN again.

__

Alles anzeigen

Thankful for any feedback and if somebody else is having the same problem.

Thanks